刘永华, 祖成奎, 赵慧峰, 韩滨, 陈江. CaO-BaO-Al2O3红外玻璃的形成及制备[J]. 红外与激光工程, 2012, 41(7): 1689-1694.
引用本文: 刘永华, 祖成奎, 赵慧峰, 韩滨, 陈江. CaO-BaO-Al2O3红外玻璃的形成及制备[J]. 红外与激光工程, 2012, 41(7): 1689-1694.
Liu Yonghua, Zu Chengkui, Zhao Huifeng, Han Bin, Chen Jiang. Glass-forming ability and preparation on CaO-BaO-Al2O3 glasses[J]. Infrared and Laser Engineering, 2012, 41(7): 1689-1694.
Citation: Liu Yonghua, Zu Chengkui, Zhao Huifeng, Han Bin, Chen Jiang. Glass-forming ability and preparation on CaO-BaO-Al2O3 glasses[J]. Infrared and Laser Engineering, 2012, 41(7): 1689-1694.

CaO-BaO-Al2O3红外玻璃的形成及制备

Glass-forming ability and preparation on CaO-BaO-Al2O3 glasses

  • 摘要: 通过添加BaO增加了铝酸钙玻璃的成玻能力,确定了CaO-BaO-Al2O3三元系统的成玻区域:25~45 mol%的Al2O3,45~65 mol%的CaO, 0~18 mol%的BaO,在成玻区域内采用Hruby值研究Al2O3/CaO值和BaO含量对系统成玻能力的影响,发现当Al2O3/CaO值为0.60、BaO含量为8 mol%时,系统的成玻能力最强。以成玻能力最好的56 CaO-8 BaO-36 Al2O3组成为基础,将真空烧结后几乎不含水的玻璃配合料分别在大气环境下、干燥氮气保护以及干燥氮气保护+CCl4搅拌等3种不同的条件下进行熔制,分析玻璃的红外透过光谱和残余水分含量。结果表明:采用干燥氮气保护+CCl4搅拌的方法,7 mm玻璃在2.9 um的透过率接近84%,残余水分含量仅为0.003 7,基本消除了OH-1的影响。

     

    Abstract: Glass-forming ability of calcium aluminate glasses is improved with the actlition of BaO, glass-forming region of CaO-BaO-Al2O3 ternary system is identified which is the area with content of Al2O3 between 25 mol% and 45 mol%, CaO between 45 mol% and 65 mol% and BaO between 0 mol% and 18 mol%. According to the study of ifrcdo, value. Influences of the ratio of content of Al2O3 and CaO(A/C) and the content of BaO on glass-forming ability were discussed based on the value of Hruby. It was found that glass-forming ability of 56 CaO-8 BaO-36 Al2O3 is best when the value of A/C is 0.60 and the content of BaO is 8 mol%. Batches without any water sintered in normal air inthe cicwstance, protected by dry nitrogen as well as stirred with CCl4 respectivelf into, 30 as to detect as IR-transmittance spectrum and investigated by residual contents of water namely B(OH). which indicated that the transmittance at 2.9 m is nearly 84% and the residual B(OH) is 0.003 7. It was demonstrated that hydroxyl was almost removed by stirring with CCl4 while protected by dry nitrogen.

     

/

返回文章
返回